
Repair
- Complete RO system inspection and diagnosis
- Repair of pump, SMPS, membrane and filters
Doorstep RO Repair, Installation & AMC in Kochi

Aquaguard RO Service Kochi always stands whenever you call us for service. You must schedule a Aquaguard RO service to experience our satisfactory and low-cost service in Kochi. Aquaguard RO Service Kochi always care for your schedule with the vast service team.
Packages










If your Aquaguard RO is giving trouble in Kochi, you are probably already noticing one or two clear signs: weak water flow, bad taste, unusual noise, leakage, or the unit not making water at all. In most cases, the problem is not “mystical” and it follows a pattern based on which stage is failing. Below is the same order a technician uses, so you know what to check first and what to expect during Aquaguard RO service in Kochi by Water Purifier Care India (WPCI).
Bad taste or salty taste: often indicates RO membrane ageing or membrane fouling (especially if pre-filters are overdue).
Bad smell (stale/chemical) or black particles: usually points to carbon filter saturation, poor flushing, or disturbed sediment filter stage during heavy monsoon turbidity.
Slow flow / low output: commonly a choked sediment or carbon pre-filter, low inlet pressure, clogged flush valve/drain, or a failing booster pump.
Leakage from under the unit or around the housing: can be a housing O-ring issue, loose fittings, cracked drain line, or water escaping from inside due to worn seals.
Continuous running / auto shut-off not working: often a fault in pressure switch, float/level control, storage tank sensing, or solenoid valve (SV) timing.
No water / RO not starting: typical causes are very low inlet pressure, electrical issue (SMPS/PCB), tripped protection, or air lock after water supply interruption.
Quick verification first: check whether the issue is taste, flow, leak, or “no production”, and note any recent power cuts or inlet water changes.
Measure inlet water condition: look at supply pressure (municipal vs borewell), how steady it is, and whether monsoon water turbidity is high.
Check pre-filtration: inspect sediment pre-filter and pre-carbon filter condition (pressure drop, clogging, and colour).
Check RO stage: test RO membrane performance and check for membrane fouling/scaling; confirm flush function and waste water flow.
Check storage and controls: look at storage tank level control/float, flow restrictor behaviour, and solenoid valve (SV) switching.
Electrical and leak checks: verify booster pump/SMPS function, check connections for leakage, and inspect housing O-rings and fittings; clean and reassemble with correct seating.
Kochi input water can be hard and sometimes highly turbid during monsoon. That accelerates scaling and clogs pre-filters faster than “ideal” conditions. Typical maintenance timing helps you avoid membrane damage, but actual replacement depends on your inlet TDS and usage hours.
RO stage / part | Typical replacement or service interval |
|---|---|
Sediment pre-filter (PP/UF pre-stage) | Every 3-6 months |
Pre-carbon filter (and post-carbon if used) | Every 6-12 months |
RO membrane | Usually 2-3 years (earlier if TDS is high or filters are delayed) |
UV lamp (if present in your model) | About 12 months of running time |
UF cartridge (if your unit uses it) | Often 6-12 months depending on turbidity |
Booster pump checks / service | As needed; frequent issues show up as low pressure or weak output |
You can safely check: whether the inlet water supply is on, whether overhead tank has water, and whether the machine is receiving power.
You can safely observe: whether water output is improving after flushing (if your model supports it) or if the leak is active only during production.
Do not open the membrane housing or disturb RO tubing if you do not have the correct O-rings and fittings; leaks can worsen after reassembly.
If you smell a strong chemical/stale odour, see black flakes, or the unit repeatedly stops and restarts, it usually needs filter/membrane inspection.
If the unit is leaking from the housing area, shut it down and call a technician; that is not a “tighten and forget” situation.
If auto shut-off fails (continuous running) or storage tank is not filling, controls and sensing need proper checks.
In an Aquaguard RO service in Kochi, the cost is mainly decided by what the diagnosis shows: whether it is just cleaning and filter change, or a membrane replacement, UV/UF replacement, booster pump/SMPS repair, or a solenoid valve (SV) and control issue. The technician also considers whether the inlet pressure is low (which may require troubleshooting of the supply setup) and whether there is leakage from seals that needs part replacement. The time taken depends on access to the unit, severity of clogging/scaling, and whether parts need to be ordered or are available during the visit. Repair is usually worth it when the RO membrane can still perform after flushing and pre-filters are corrected; if membrane output is consistently poor or the system has repeated control faults, replacement and full stage cleaning becomes the practical route. WPCI technicians typically start with correct stage diagnosis so you do not pay for unnecessary parts.
If you tell us what you are seeing right now (taste, smell, flow, leakage, or no water) and how long it has been happening, the next step is simple: book an Aquaguard RO service visit in Kochi and let the technician check the filtration stage first, then the RO membrane and controls. That order prevents small issues from turning into membrane failure.
Why Trust Us?
in Kochi — Reliable, Fast & Professional
Technician visits your location for service
Guaranteed service visit in 48 hours for any request
Trained technicians for high quality service and repairs
Only high quality spare parts used for repairs
Watch
FAQ
Find answers to common questions about our services
Kerala has a strong tradition of boiling drinking water, often with karingali, pathimugam or jeera to give it colour and flavour. A water audit in the Kochi corporation area once found that the vast majority of households boiled their water, yet only a small fraction owned a purifier. That is changing quickly, and Aquaguard is one of the brands most Kochi families choose when they make the switch. This page explains how we service Aquaguard purifiers in Kochi and what makes the local water different.
Boiling kills germs very well. It does not remove iron, sediment, chlorine taste or dissolved salts, and it costs gas and time every day. An Aquaguard with RO and UV handles germs and dissolved impurities together, while a UV or UV + UF Aquaguard handles germs and fine particles. For many Kochi homes the best results come from a purifier sized to the actual source, kept properly serviced. Some families still enjoy herbal boiled water and simply start with purified water, which is a perfectly good habit.
Kerala Water Authority supply from the Periyar, treated at Aluva, is soft. West Kochi also receives Muvattupuzha river water through the Maradu treatment plant. Neither is high in TDS under normal conditions. Household wells and borewells are another matter: across the city they frequently carry iron, and wells sited close to septic tanks can carry coliform bacteria. Apartment complexes in Kakkanad, Thrikkakara and along the Seaport-Airport Road often mix KWA water, borewell water and tanker water in the same sump.
Kochi takes heavy rain from both the southwest and northeast monsoons. When the Periyar runs high and muddy, KWA has at times reduced pumping because turbidity at the intake rose sharply. Even treated water can arrive cloudier than usual in those weeks, especially after pipeline repairs. The first filter in your Aquaguard takes this load. If water from the purifier slows down in July or August, a choked pre-filter is the first suspect, and it is an inexpensive fix compared with a membrane.
Aura, Delight, Enhance, Glory, Marvel, Ritz, Superb, Sure, Blaze and Designo, plus older Reviva, Geneus and Total units still common in Ernakulam homes.
| Fault | Common Cause in Kochi |
|---|---|
| Flow very slow after the rains | Pre-filter choked by turbid water |
| Water tastes flat | Taste Adjuster closed on soft water, or Mineral Guard exhausted |
| Brownish deposits inside filter bowls | Iron from well or borewell water |
| UV warning or no UV light | Lamp at end of life or moisture in the connector |
| Purifier dead after a storm | Adaptor damaged by surge or dampness |
| Service alert keeps blinking | Counter not reset after the last cartridge change |
On KWA water, every six months. On well or borewell water, every three to four months, since iron and bacteria load the filters quickly. A short check after the peak monsoon weeks catches choked pre-filters before they strain the pump.
Kochi's air stays damp for much of the year, and kitchens near the backwaters or the sea also get salt in that moisture. An Aquaguard fixed beside an open window, above a sink that splashes, or on a wall that seeps during the rains will see its adaptor, sensors and screws corrode years early. Choose a dry inside wall with a power socket close by, keep the socket off the floor-level splash zone, and leave a little space behind the unit for air. When we install or relocate a purifier, we check these points first.
Kakkanad, Thrikkakara, Edappally, Palarivattom, Vennala, Chalikkavattom, Vyttila, Elamkulam, Kadavanthra, Kathrikadavu, Kaloor, Ernakulam South, Thevara, Panampilly Nagar, Pachalam, Vaduthala, Thrippunithura, Maradu, Kalamassery and Eloor.
Water Purifier Care India is an independent multi-brand service provider. We are not Eureka Forbes Ltd and not the official or authorised Aquaguard service centre. We refer to Aquaguard only so you know which purifiers we handle. Owners whose unit is still inside its manufacturer warranty period may want to approach Eureka Forbes first.
Call 8506096743 or book online through this page for Aquaguard RO service in Kochi.