
Repair
- Complete RO system inspection and diagnosis
- Repair of pump, SMPS, membrane and filters
Doorstep RO Repair, Installation & AMC in Gorakhpur

RO Service Center always stands whenever you call us for service in Gorakhpur. You must schedule a RO service to experience our satisfactory and low-cost service in Gorakhpur. RO service Centre always care for your schedule with the vast service team.
Packages










If your RO water purifier in Gorakhpur is acting up right now, the fix depends on the symptom. Bad taste, salty water, slow or no output, dirty water, leakage, or continuous running usually point to different parts like pre-filters, the RO membrane, the UV lamp, or the storage tank. When you call WaterPurifierCareIndia (WPCI), the technician typically starts by matching your symptom to the likely stage and then checks only what matters.
Bad or salty taste: often the RO membrane is exhausted or bypassing; sometimes post-carbon is depleted
Dirty/colored water even after RO: sediment pre-filter is choked or carbon filter is failing
Slow filling / low water output: pre-filter clogging, low inlet pressure (common in municipal supply fluctuations), or booster pump issue
Machine keeps running but tank does not fill: float valve problem, solenoid valve (SV) sticking, or storage tank/pressure switch issue
Water leakage from housing/under unit: loose fittings, cracked RO housing, or worn O-rings in filter stages
Smell like chlorine or musty odor: carbon filter saturation or UV lamp not working (depending on model)
Check water source and inlet pressure (borewell vs municipal, and whether pressure drops)
Inspect pre-filter and carbon stages for clogging, damage, and signs of scaling
Measure TDS before and after RO with a TDS meter to confirm membrane performance
Check UV lamp/UF cartridge (if present) and wiring/indicator status
Inspect storage tank fill control: float valve movement and any related switches
Look for leaks at housings, tubing, and filter head O-rings, then verify drain line flow
Gorakhpur water often has higher hardness and seasonal turbidity, so filters get loaded faster. Sediment (pre-filter) typically needs changing every 3-6 months. Carbon filters usually last around 6-12 months, depending on taste and inlet quality. RO membrane commonly lasts about 2-3 years, but high TDS and poor pre-filter maintenance can shorten it. UV lamp run time is usually around 1 year, depending on your usage hours.
RO stage / part | Typical replacement or service interval (typical) |
|---|---|
Sediment pre-filter | 3-6 months |
Pre-carbon / carbon filter (taste/odor control) | 6-12 months |
RO membrane | 2-3 years (varies with inlet TDS and usage) |
UV lamp (if fitted) | ~1 year of running time |
The cost mostly depends on which stage is failing (pre-filters, carbon, RO membrane, UV/UF, pump/SMPS, SV/float), plus how many parts need replacement and whether there is internal scaling. Time also varies: a filter-only service is usually quicker, while membrane diagnosis and tank/control issues take longer. Repair is worth it when the problem is local (choked pre-filters, carbon saturation, SV/float failure). If TDS rejection is consistently poor due to membrane exhaustion, replacement is usually the practical fix.
Note your exact symptom: salty taste, dirty water, slow output, leakage, or no filling
Check if the storage tank is empty or overflowing (helps point to float/SV issues)
Observe whether the RO unit makes normal sound while running (continuous running matters)
If water output is slow, check whether inlet water pressure is low at that time
Do not open housings or cut seals; if you see active leakage, switch off the unit and call
If you tell the technician your symptom and when it started, WPCI can reach the correct diagnosis faster. Your next sensible step is to book an RO service visit in Gorakhpur and keep your last TDS reading (if you have one) ready.
Why Trust Us?
in Gorakhpur — Reliable, Fast & Professional
Technician visits your location for service
Guaranteed service visit in 48 hours for any request
Trained technicians for high quality service and repairs
Only high quality spare parts used for repairs
Watch
Live activity
Trusted by customers across India
FAQ
Find answers to common questions about our services
Unlike many river cities, Gorakhpur does not pump the Rapti into its taps. Since piped supply began in the 1950s, the Jalkal department of Gorakhpur Nagar Nigam has relied on tubewells that lift groundwater and send it through a network of overhead tanks spread across the city's wards. Thousands of households also keep a hand pump or a private submersible, especially in older mohallas and in the newer colonies that have grown beyond the municipal network.
That groundwater is usually not very salty. One study of hand pump water across the city recorded average TDS of only about 200 mg/l. The real issues are different: noticeable hardness, dissolved iron that turns buckets orange, and the risk of bacterial contamination in shallow sources when the water table rises. A purifier in Gorakhpur has a slightly different job than one in a high-salt city, and servicing it well means understanding that.
This is the first question our technicians answer, because many families either overspend on RO or rely on a UV unit that cannot cope with their water.
We measure input TDS at your tap and look at the colour of your pre-filter before suggesting anything. If your current machine already suits the water, we say so.
Most RO units sold today have a TDS or mineral controller, a small valve that mixes some unprocessed water into the RO output. With low-TDS Gorakhpur water, people sometimes notice the RO output tastes flat, at 20 to 40 mg/l, and ask for it to be raised. That is reasonable, but only if the bypass stream is itself safe. Because that blended water skips the membrane, it must still pass through the UV or UF stage. We set the valve to bring output into a pleasant range while checking that the bypassed water is not carrying iron or turbidity into your glass.
| What You Notice | Usual Reason Here |
|---|---|
| Yellowish or metallic-tasting output | Iron breaking through an overdue sediment or carbon filter |
| Flow drops to a trickle | Pre-filter choked with rust and silt, or a fouled membrane |
| White film inside the tank | Hardness building up on membrane and tank walls |
| Purifier runs but tank never fills | Weak pump or low inlet pressure from the overhead tank |
| Musty smell after monsoon | Bacterial growth in an uncleaned tank or a dead UV lamp |
| Unit stops after a power cut | SMPS or adaptor damaged by voltage swings |
Gorakhpur sits in a low, flat stretch between the Rapti and Rohin rivers, with Ramgarh Tal on its south-eastern side. During heavy rain, the water table climbs close to the surface and several low-lying colonies see waterlogging. Shallow hand pumps and poorly sealed borewells can then draw in water contaminated by drains and septic tanks. Health authorities in the region have long stressed safe drinking water and sanitation as part of controlling water-borne illness.
For purifier owners, this means two things. First, the UV lamp or UF membrane must be working before July, not after. Second, the storage tank needs cleaning at the start and end of the rains. We recommend a full service in June and a quick check in September for homes on private sources.
On Nagar Nigam supply, a service every six months keeps most purifiers in good shape. Homes using private borewells with visible iron should plan on three to four months between sediment filter changes. If your sediment cartridge turns dark orange within weeks, an external iron-removal pre-filter is often worth adding, and we can install one.
We install new RO, UV and UF purifiers of all major brands, including wall mounting, inlet tapping and drain connection. If you are moving house within the city, we uninstall, cap the lines and reinstall at the new address. For families who would rather not track filter dates, an annual maintenance contract covers scheduled visits and lets us plan replacements based on your water.
Golghar, Civil Lines, Betiahata, Mohaddipur, Taramandal, Rapti Nagar, Shahpur, Gorakhnath, Basharatpur, Asuran, Bichhiya, Rustampur, Padri Bazar, Daudpur, Humayunpur, Jatepur, Kunraghat, Khorabar, Divya Nagar, Medical College Road and nearby colonies.
Water Purifier Care India is an independent multi-brand purifier service provider.
Call 8506096743 or book through this page for RO service in Gorakhpur.