
Repair
- Complete RO system inspection and diagnosis
- Repair of pump, SMPS, membrane and filters
Doorstep RO Repair, Installation & AMC in Bhubaneswar

Eureka Forbes RO Service Bhubaneswar always stands whenever you call us for service. You must schedule a Eureka Forbes RO service to experience our satisfactory and low-cost service in Bhubaneswar. Eureka Forbes RO Service Bhubaneswar always care for your schedule with the vast service team.
Packages










If your Eureka Forbes RO is giving trouble in Bhubaneswar, it is usually not a “mystery” problem. You notice it as bad taste or smell, low or slow RO water, continuous running, noise from the machine, or even leakage under the unit. This RO service page is for those exact situations, so you know what to check first and what a technician will inspect in the right order.
Bad taste or salty water: most often the RO membrane is exhausted, or the post-carbon stage is not working properly.
Bad smell (especially musty/chemical) or discolored output: often a carbon filter saturation, stagnant water in the storage tank, or improper cleaning of the housing.
Slow RO flow / weak output: usually a clogged sediment pre-filter, low inlet pressure, or scaling on the membrane due to hard water.
Machine runs continuously / auto shut-off not happening: commonly a float valve issue, solenoid valve (SV) fault, air leak in lines, or a pressure switch/control problem.
Noise during filtering (grinding, humming, rattling): can be a failing booster pump, debris in the flow path, or a worn internal component that needs inspection.
Leakage from under the RO: often a housing O-ring / fitting leak, loose drain line, or a cracked fitting near the unit; do not keep using it until checked.
Check inlet water condition: municipal vs borewell, inlet TDS, and whether monsoon turbidity is clogging the system.
Measure performance at the TDS meter points: raw water vs RO output to confirm if rejection is dropping (membrane issue) or if carbon stage is masking taste/smell.
Inspect pre-filters and flow: sediment filter, pre-carbon condition, and pressure drop that causes slow filling.
Check membrane and fittings: look for scaling signs, verify membrane pressure behavior, and inspect drain flow and seals for internal bypass.
Check storage tank and shut-off: confirm float/level sensing, check solenoid valve (SV) response, and verify whether the unit is stopping when it should.
Run a final rinse + function test: flush, then retest output quality and flow; confirm no leakage and stable operation.
Note what changed: after a power cut, after monsoon rains, after moving the unit, or after changing filters.
Observe the output pattern: does it start normally and then slow down, or is it slow from the beginning?
Check for visible leaks: water under the RO base, wetness around fittings, or dampness near drain line connections.
Check whether the storage tank has water: if the tank is empty or not filling, the issue can be float valve, inlet pressure, or SV.
Look at the unit behavior: does it keep running even when tank is full, or does it stop too early?
If you have a TDS meter: compare raw vs RO output once (do not guess). Large gaps usually mean membrane is still doing its job.
RO stage (typical) | Typical interval in Indian conditions |
|---|---|
Sediment pre-filter | Every 3-6 months (faster in monsoon/borewell turbidity) |
Pre-carbon filter | Every 6-12 months (smell/taste issues mean it is due) |
Post-carbon filter | Every 6-12 months (taste improvement depends on it) |
RO membrane | Usually 2-3 years (depends on input TDS, scaling, usage) |
UV lamp (if present) | About 1 year of running time (only if your model has UV) |
Cost is decided mainly by what the technician finds: whether it is a simple filter replacement, a leakage from fittings/O-rings, a booster pump or SMPS issue, or RO membrane replacement. The inlet condition in Bhubaneswar matters too, because high TDS and hard water can cause faster membrane scaling and more cleaning work. Repair time depends on parts availability and the severity (for example, a stuck solenoid/float and line leaks take longer than routine filter servicing). In most cases, repairing is worth it when the RO output quality can be restored by cleaning and replacing the correct stage; if the membrane performance is already far below expected and bypass/tank issues keep repeating, the technician may recommend membrane replacement to stop recurring complaints. Water Purifier Care India (WPCI) typically diagnoses first, then recommends the exact stage that needs attention, instead of replacing everything blindly.
If you see leakage under the RO, stop use and call for inspection. Water near electrical parts is a risk.
If output is salty from day to day, do not keep running it hoping it will improve; membrane exhaustion or bypass needs checking.
If the unit keeps running continuously, do not ignore it; shut-off problems can damage components over time.
If you do not have a TDS meter, avoid “trial and error” filter swapping; you may spend money but miss the real fault.
If there is an unusual burning smell or repeated fuse trips, stop and call a technician (electrical/control issue).
If your Eureka Forbes RO in Bhubaneswar is showing any of the symptoms above, the sensible next step is to arrange a diagnosis visit. Tell the technician the exact complaint (taste/smell/slow flow/leak/no shut-off) and share whether your water source is municipal or borewell—this helps them check the correct stage first and fix it faster.
Why Trust Us?
in Bhubaneswar — Reliable, Fast & Professional
Technician visits your location for service
Guaranteed service visit in 48 hours for any request
Trained technicians for high quality service and repairs
Only high quality spare parts used for repairs
Watch
FAQ
Find answers to common questions about our services
In many Bhubaneswar homes, the first water purifier the family ever owned was a Eureka Forbes unit, often bought from a door-to-door salesman in the 1990s or 2000s. Some of those households still have one of the old models working, while their children have since bought a newer Aquaguard RO or a budget AquaSure. Our Eureka Forbes RO service in Bhubaneswar covers that whole family of products, old and new, under one visit.
Eureka Forbes has sold purifiers under more than one name over the years, and owners are not always sure what they have. Broadly, there are three groups:
Each group uses different cartridges and electronics, so the first step on any visit is to identify the exact model.
Newer Eureka Forbes purifiers usually have filter-life counters, alert lights and compact sealed cartridges. Older units tend to have separate housings, simpler UV systems and fewer sensors. That makes them easier to repair, but parts are not always available, and plastic housings can become brittle with age. We tell you plainly when a legacy unit is worth repairing and when its parts are no longer sensible to source. Where a new purifier is the better choice, we explain why and leave the decision to you.
Much of the capital receives treated river water through WATCO, drawn mainly from the Kuakhai with support from the Daya and the Mahanadi at Mundali. This water is generally low in dissolved salts, which is why many older UV-only Eureka Forbes units have served families well for years.
In older parts of the city, including Old Town around the Lingaraj temple and some of the early planned Units, internal plumbing is decades old, and galvanised pipes can shed rust. In newer peripheral areas, borewell water is often added to the supply, and it may contain iron and higher hardness. UV purifiers do not remove either, so if your source has changed, the purifier that suited you ten years ago may need an RO stage now.
| Product Type | Typical Fault | Usual Cause |
|---|---|---|
| Legacy UV purifier | UV lamp not lighting | Aged lamp or failed choke |
| Older RO purifier | Cracked housing, slow leak | Brittle plastic after many years |
| Newer Aquaguard RO | Persistent service alert | Filter counter due or not reset after service |
| AquaSure RO | Low flow | Pre-filter clogged by silt or iron |
| AquaSure gravity | Very slow filtration | Cartridge exhausted or choked |
| Any electric model | Dead after a storm | Surge damage to adaptor or pump |
Odisha's coastline sees regular cyclones and long, wet monsoons. Older Eureka Forbes units with exposed wiring and simple adaptors are more vulnerable to surges and to damp corrosion than newer ones. A spike protector costs little compared to a pump or adaptor. If a unit has been switched off for days during a storm, run water through it for a few minutes before drinking from it again.
Every six months for purifiers on treated piped water, and every three to four months where borewell water is used. UV lamps generally need yearly replacement. Legacy units benefit from a thorough annual check of housings, seals and wiring.
Gravity AquaSure units follow a different rule. Their cartridges are rated for a certain volume of water, so a large family will need replacements sooner than a couple living alone. If the flow from a gravity unit slows noticeably, or the water starts to taste of the storage chamber, the cartridge is likely spent and should be changed rather than cleaned.
Old Town, Lingaraj Nagar, Unit 2, Unit 6, Forest Park, BJB Nagar, Kapila Prasad, Saheed Nagar, Satya Nagar, Bhoi Nagar, Nayapalli, IRC Village, Acharya Vihar, Vani Vihar, Chandrasekharpur, Niladri Vihar, Patia, Khandagiri, Baramunda, Sundarpada and surrounding areas.
Water Purifier Care India is an independent multi-brand service company. We are not Eureka Forbes Ltd or its authorised service centre, and the Eureka Forbes, Aquaguard and AquaSure names are used only to describe the products we maintain. If your purifier is under warranty with the manufacturer, you may wish to contact them first.
Call 8506096743 or book through this page for Eureka Forbes RO service in Bhubaneswar.