
Repair
- Complete RO system inspection and diagnosis
- Repair of pump, SMPS, membrane and filters
Doorstep RO Repair, Installation & AMC in Makdi

Livpure Service Center Makdi always stands whenever you call for service. You must schedule a Livpure Service to experience it's satisfactory and low-cost service in Makdi. Livpure RO Service Makdi always care for your schedule with the vast service team.
Packages










If your Livpure RO is acting up in Makdi, you will usually notice it in daily use first: bad taste or smell, salty water, slow flow, repeated noise, leakage, or the unit not filling properly. These symptoms often point to specific parts failing or getting clogged. At Water Purifier Care India (WPCI), the technician diagnosis starts from what you report and then checks the RO stages in a set order so the right fix is done, not a random parts change.
Bad smell or bad taste (especially after storage in tank): usually a carbon stage issue, dirty post-carbon, or bacterial growth due to low flow and long idle time
Salty taste or higher TDS reading: usually RO membrane exhaustion, a leaking/failed membrane housing seal, or low rejection due to low inlet pressure
Slow water flow or weak output: usually a choked sediment/pre-filter, clogged carbon, low inlet pressure, or a failing booster pump
Frequent running with low output / no steady flow: usually solenoid valve (SV) switching problem, air lock, pressure issues, or RO drain restrictions
Leakage from under the unit or from the filter housing: usually housing O-rings worn, loose clamps, cracked fittings, or overflow from tank/float valve issue
No water / unit not filling: usually inlet valve/float valve stuck, lack of supply pressure, or an electrical issue like SMPS/pump not starting
Confirm the complaint with quick checks: taste/smell when possible, output rate, whether there is leakage, and whether the unit is filling the storage tank normally
Check inlet water conditions: municipal vs borewell, approximate TDS/solids, and whether monsoon turbidity is causing fast pre-filter choking
Inspect the pre-filters and carbon stages: look for clogging, bypass risks, and correct fit of sediment pre-filter, pre-carbon, and post-carbon cartridges
Test membrane performance: RO membrane rejection basics using TDS meter readings (inlet vs RO output), and check for signs of membrane scaling or seal leakage
Check water path controls: solenoid valve (SV) operation, pressure switch/flow behaviour, drain line restriction, and whether the unit is cycling correctly
Verify storage and safety parts: float valve/tank level switching, UV lamp status (if your model uses UV), and check for any overflow or stagnant water
Makdi households often face higher total dissolved solids (hard water) and seasonal turbidity during monsoon. When sediment and carbon filters are not changed on time, the RO membrane gets overloaded with scaling and gets exhausted early. Voltage fluctuation can also stress the booster pump/SMPS, which shows up as weak flow, repeated stops, or unusual noise. If you store water in an overhead tank and the supply is not steady, the unit can run irregularly and post-treatment stages like post-carbon or UV can underperform.
Check whether the problem is only with RO output or also with tank water: smell/taste right after a refill tells more
Observe the filling cycle: does the unit fill the tank at all, or does it keep running without building pressure
Look for obvious leakage: around filter housings, quick-connect joints, and under the RO housing (do not open housings yourself if you are not trained)
Confirm inlet supply: when borewell supply drops or pressure is low, RO output slows and membrane performance falls
Note any recent changes: power cuts, new borewell water use, monsoon start, or filter change date (approximate is fine)
RO stage in your Livpure | Typical replacement interval (Makdi conditions) |
|---|---|
Sediment pre-filter | Every 3-6 months (faster if monsoon turbidity is high) |
Pre-carbon / post-carbon filters | Every 6-12 months (depends on taste/smell complaints) |
RO membrane | Usually 2-3 years (earlier with hard water scaling or low inlet pressure) |
UF cartridge (if your model uses it) | About 12-18 months depending on fouling |
UV lamp (if present) | Around 1 year of running time |
The cost mostly depends on which stage is actually failing: whether it is a clogged pre-filter/carbon cartridge, an RO membrane replacement need, leakage requiring housing O-ring/fitting work, or an electrical issue in the pump/SMPS. Time also changes by the diagnosis outcome—simple cartridge change and sanitization is quicker, while membrane testing, seal/housing work, or solenoid valve correction takes longer. In most cases, if only filters are exhausted and there is no major membrane scaling or seal leakage, repair is worth it. If you have repeated salty output, high rejection loss, and frequent cycling problems together, the technician may recommend membrane/housing fixes rather than repeated filter-only changes. Water Purifier Care India (WPCI) typically follows the diagnosis-first approach so the fix matches the actual fault on your Livpure RO unit in Makdi.
If you are facing bad taste/smell, slow output, leakage, or the unit not filling properly, do not keep running it daily and guessing. Call Water Purifier Care India (WPCI) for a diagnosis visit in Makdi, and share the exact symptoms you noticed, when they started, and whether your inlet water is borewell or municipal. That single call helps the technician reach the correct part and restore your RO performance faster.
Why Trust Us?
in Makdi — Reliable, Fast & Professional
Technician visits your location for service
Guaranteed service visit in 48 hours for any request
Trained technicians for high quality service and repairs
Only high quality spare parts used for repairs
Watch
FAQ
Find answers to common questions about our services
There are various Livpure Service Center in Makdi. Thus you can easily book your water purifier services in Makdi. At the Livpure Service Center in Makdi, you will receive all kinds of water purifier services like maintenance service, Livpure water purifier repair services and various others. It is said to be an electrical device; a Livpure water purifier demands regular service. Makdis people can drink contamination free water all the time they need to drink water. And the Livpure Service Center in Makdi helps them to get the best solution for this.
But Livpure water purifier is also a complex device that needs an expert hand for servicing; thus, the Livpure RO Service Center's role in Makdi has become crucial. At Livpure RO Service Center in Makdi, all the water purifier service engineers are expert and fully trained who believe in providing the best and mind-blowing services inside Makdi. Most of the people in Makdi avoid Livpure water purifier services due to the high service cost. Still, at the Livpure Service Centre, you will get all kinds of water purifier services at the best and affordable price. Thus hiring a service engineer at the Livpure Service Center can be an option for Makdis people.
| Livpure RO Service Type | Contact Number |
| Livpure Repair Service Makdi | 8506096743 |
| Livpure RO Installation in Makdi | 8506096743 |
| Livpure RO AMC in Makdi | 8506096743 |
If you are searching for the Livpure service center in Makdi, you can search for the Livpure Service Center Near Me in Makdi on Google. But when you make this search on Google, the search engine collects all the Livpure service center in Makdi near your location and display on your device. But for a better result must ensure that your mobile location is enabled. Booking Livpure water purifier service from your nearest location in Makdi ensures that you will get your water purifier service done quickly. However, Makdis Livpure Service Center promises that they will resolve your water purifier issues within 24 hours. Thus the search for the Livpure Service Centre Near Me in Makdi, book your water purifier services and enjoy hassle free water purifier service at your doorstep anywhere in Makdi.
| Service type | Charges |
| Installation | Start from Rs.499/ |
| Uninstallation | Start from Rs. 399/- |
| Basic Service/Repair | Start from Rs. 399/- |
| AMC | Start from Rs. 999/- |
Livpure water purifier filters get muddy due to continuous removal of the water pollutant present in the water because Makdis water quality is inferior. When the water purifier filters get dirty, the drinking water purifier suffers, which can be harmful to Makdis people. Thus it is recommended to book Livpure water purifier services at Livpure Service Center in Makdi. Livpure water purifier demands regular services and demand for the expert, and in Makdi, not all water purifier service providers are trusted except the Livpure Service Centre.
Makdi people can also book their Livpure water purifier service without visiting the Livpure Service Center in Makdi. Yes, now with the advancement in technology has made this possible, now you can easily book your water purifier service from anywhere in Makdi by calling at Livpure Service Centre. The service center executive at Livpure Service Center in Makdi is friendly, helping you with all kinds of water purifier service related queries.
| 1. Book Livpure Service in Makdi by Call us/Fill the details in the enquiry form. |
| 2. Get Technician Confirmation and schedule your service for your Pureit water purifier in . |
| 3. Technician will Visit at your place & Complete Work |
| 4. Make Payment and Share your valuable feedback to Pureit service center. |