
Repair
- Complete RO system inspection and diagnosis
- Repair of pump, SMPS, membrane and filters
Doorstep RO Repair, Installation & AMC in Rajkot

Aquaguard RO Service Rajkot always stands whenever you call us for service. You must schedule a Aquaguard RO service to experience our satisfactory and low-cost service in Rajkot. Aquaguard RO Service Rajkot always care for your schedule with the vast service team.
Packages










If your Aquaguard RO is acting up in Rajkot, you usually notice it first as taste change, bad smell, salty water, slow flow, leakage, or the machine not filling. Each symptom points to a specific stage inside the RO system, so the right service is mostly about correct diagnosis. Water Purifier Care India (WPCI) in Rajkot follows a symptom-first checklist so the technician can find the exact fault, not just replace parts blindly.
Salty or metallic taste even after RO: commonly a failing RO membrane, bypass/leakage in the membrane housing, or exhausted post-carbon stage.
Water smells bad or looks discoloured: often pre-carbon/post-carbon carbon filter ageing, or storage tank contamination after low usage.
Slow water flow / weak output: usually sediment pre-filter choked (hard water scaling too), low inlet pressure from borewell/municipal line, or a weak booster pump.
RO keeps running or does not stop: typically float valve issue in the storage tank, solenoid valve (SV) sticking, or pressure switch/flow sensor problem.
Leakage near filter housing, under the machine, or from fittings: gasket/housing crack, loose clamps, or overflow due to float valve/float rod misalignment.
No water output / no filling: inlet water supply/valves closed, RO booster pump not working, or power/SMPS issue in the purifier.
Confirm the complaint and check water source type (borewell vs municipal) and whether the purifier is connected to an overhead tank.
Check inlet pressure and flow: if inlet pressure is low, RO may waste time, run continuously, or produce low output.
Inspect pre-filters and rinse/measure pressure drop: sediment pre-filter clogging is the most common cause of slow flow in hard-water Rajkot areas.
Check carbon filter health: if carbon is exhausted, taste/smell issues continue even when RO membrane is working.
Test RO performance with TDS meter readings (inlet vs RO outlet, and sometimes reject/line): this tells whether the membrane is rejecting properly.
Check storage tank and controls: float valve operation, solenoid valve sealing, and pressure/flow switches so the unit stops and starts correctly.
Inside an RO purifier, the job of each stage is different. The sediment pre-filter traps sand and suspended particles, the pre-carbon/post-carbon filters handle taste and odour, and the RO membrane removes dissolved salts. If scaling builds on the membrane, rejection drops and water can start tasting salty again. UV or UF cartridges (where present) mainly address microbial risk, but they do not correct salty TDS caused by RO membrane failure.
Stage / component | Typical interval (rough guide) | What it looks like when overdue |
|---|---|---|
Sediment pre-filter | 3-6 months | Slow filling, reduced flow, higher pressure on reject line |
Pre-carbon and post-carbon filters | 6-12 months | Bad taste/smell returns, water looks dull |
RO membrane | 2-3 years (varies) | Salty taste, high TDS in RO output, repeated membrane cleaning needed |
UV lamp (if installed) | ~12 months of running | No clear taste change, but technician checks lamp function and indicator |
Storage tank & float valve | Every 6-12 months inspection | Overflow, continuous running, inconsistent output |
What decides cost: the exact fault stage (pre-filter vs carbon vs membrane vs pump/SV/float), whether parts need replacement, and whether the RO membrane needs cleaning or full replacement.
How long it takes: simple filter change and gasket work can be quick, but membrane testing and performance validation takes longer because the technician must confirm output TDS and flow after work.
When repair is worth it: if the RO membrane still passes TDS rejection and only filters/controls are faulty, repair usually restores performance.
When replacement is considered: repeated membrane failure, heavy scaling, or persistent salty output after cleaning usually means the membrane is at end of life.
Avoid DIY in these cases: leakage from housing fittings, electrical/SMPS issues, or if the unit keeps running continuously. Wrong handling can damage the membrane housing or leave controls mis-set.
Note the exact symptom: taste, smell, flow speed, noise, leakage location, and whether the RO stops or keeps running.
Check if inlet water is available and valves are open (borewell pump schedules can cause sudden low pressure).
If there is slow flow, do not keep switching repeatedly for long periods; it can overheat the system.
Look for obvious leaks: around filter housings, drain line, and storage tank connections (do not tighten blindly if water is actively spraying).
Record any TDS meter readings you already have (inlet and RO outlet). If you do not have one, tell the technician what taste/colour changes you observe.
If you are in Rajkot and your Aquaguard RO is showing any of the symptoms above, the sensible next step is to book a diagnosis visit and share the exact symptom and when it started. WPCI technicians will check inlet pressure, filters, TDS performance, and tank/valve controls in the right order so you get the correct fix without unnecessary part swapping.
Why Trust Us?
in Rajkot — Reliable, Fast & Professional
Technician visits your location for service
Guaranteed service visit in 48 hours for any request
Trained technicians for high quality service and repairs
Only high quality spare parts used for repairs
Watch
FAQ
Find answers to common questions about our services
From March to June, Rajkot is hot and dry, with afternoon temperatures that regularly climb past forty degrees. Families drink more water, purifiers run for more hours, and the water feeding them has often been sitting in a sump or rooftop tank since the morning supply. An Aquaguard purifier copes well with this if it is maintained properly. If it is not, the heat finds every weak point: a tired pump, a choked filter, a storage tank where bacteria grow faster in warm water.
Rajkot Municipal Corporation supplies water from reservoirs such as Aji-1, Nyari-1 and Bhadar, and relies heavily on Narmada water brought in through state pipelines and the SAUNI Yojana, which refills Aji and Nyari when local rain falls short. Supply comes for a limited period each day, so homes store water. Some households also use borewells, especially in summer. Groundwater in the region tends to be hard and has been found to contain elevated fluoride and nitrate in places. The more groundwater in your mix, the harder your Aquaguard works.
Our technicians handle Aquaguard Aura, Delight, Enhance, Glory, Marvel, Ritz, Superb, Sure, Blaze and Designo models from Eureka Forbes, along with older Aquaguard Reviva, Geneus and Total units. We know the brand's features: Active Copper cartridges, Mineral Guard, the Taste Adjuster (MTDS) valve, UV e-boiling, and the service and filter-life alerts on newer models.
Aquaguard purifiers are built for Indian conditions, but a few habits make a big difference in Rajkot's summer. Do not mount the purifier where afternoon sun falls on it through a window, or right beside the gas stove. Heat makes plastic housings brittle, shortens UV lamp life and warms the water in the storage tank. Keep the purifier's tank in use rather than letting water sit for long hours. If your kitchen gets very hot, a spot on a cooler inner wall is worth the small effort of moving it. Adaptors and pumps also fail more often in summer, partly from heat and partly from voltage swings when air conditioners across a building start together.
| Problem | Usual Cause in Rajkot |
|---|---|
| Salty or heavy taste | Membrane scaling after borewell use, or Taste Adjuster too open |
| Musty smell from purified water | Warm water stagnating in the storage tank |
| Flow slows down | Sediment stage clogged by sump silt |
| Service alert lit | Filter-life counter reached; parts need checking |
| UV warning | Lamp or driver failure, often heat-related |
| Purifier dead | Adaptor or control card damaged by heat or voltage swing |
| Leaking housing | Brittle plastic or loose fittings |
The service alert on a modern Aquaguard counts time or litres, not the actual condition of the filter. On reservoir water in a small household, filters may still be fine when it lights; on borewell water in a large one, they may be finished before. We check before we replace. The Active Copper cartridge on some models releases copper gradually and needs replacing when spent, otherwise the copper benefit stops. The Taste Adjuster lets a little unpurified water through for taste. That suits mild Narmada water but should be kept low on Rajkot borewell water, where it would let fluoride and hardness back in.
Since most homes in the city receive water for only a short spell each day, what reaches the Aquaguard has usually spent hours in a sump or overhead tank. In peak summer, a rooftop tank in direct sun can get quite warm. Warm, stored water carries more organic matter and microbes into the first stages, and the purifier's own storage tank is then the last place where germs can grow before you drink. Models with UV in or after the tank help here, but only if the lamp works. We test that lamp on every visit, and we clean the internal tank thoroughly rather than just rinsing it.
Book an Aquaguard service every five to six months on RMC supply and every three to four months if groundwater or tankers are involved. A pre-summer visit in February or March is the single most useful one, and cleaning your sump and rooftop tank at the same time helps the purifier's first stage last much longer.
We cover University Road, Kalawad Road, 150 Feet Ring Road, Raiya Road, Yagnik Road, Amin Marg, Mavdi, Nana Mava, Mota Mava, Kothariya, Gondal Road, Bhaktinagar, Sorathiyawadi, Jamnagar Road, Morbi Road, Kuvadva Road, Gandhigram, Race Course, Ghanteshwar and Madhapar, usually on the same or next day.
Water Purifier Care India is an independent multi-brand service provider and is not Eureka Forbes Ltd or an authorised Aquaguard service centre. We refer to Aquaguard purely to identify the purifiers our team maintains. If your purifier is under manufacturer warranty, please check with Eureka Forbes before booking us.
Call 8506096743 or book online through this page for Aquaguard RO service in Rajkot.