
Repair
- Complete RO system inspection and diagnosis
- Repair of pump, SMPS, membrane and filters
Doorstep RO Repair, Installation & AMC in Solapur

Eureka Forbes RO Service Solapur always stands whenever you call us for service. You must schedule a Eureka Forbes RO service to experience our satisfactory and low-cost service in Solapur. Eureka Forbes RO Service Solapur always care for your schedule with the vast service team.
Packages










If your Eureka Forbes RO is acting up in Solapur, you usually notice it first in day-to-day water use: slow flow, bad taste, salty water, foul smell, leakage, or the RO stopping mid-cycle. For fast diagnosis, a technician follows the symptom first, then checks inlet pressure, pre-filters, carbon stages, membrane performance, and storage tank filling. Water Purifier Care India (WPCI) service visits in Solapur focus on finding the exact fault, not just doing a routine wash.
No water / RO not producing: often low inlet pressure, electrical issue (SMPS/relay), closed shut valves, or a clogged sediment pre-filter.
Slow filling or intermittent production: usually choked pre-filter, weak booster pump, or a failing float valve / storage tank filling control.
Bad taste (bitter/salty) or water smells odd: usually exhausted RO membrane, carbon filter not removing taste/odour, or contamination after a long storage gap.
High TDS on the outlet (if you check with a meter): typically RO membrane decline, wrong drain settings, or scaling inside the membrane housing.
Leakage from the RO housing or under the unit: often loose fittings, cracked housings, membrane housing gasket issue, or seepage from tubing.
Loud noise, vibration, or water hammer: commonly booster pump strain, air in lines, clogged flow restrictor/drain line, or pressure fluctuation from borewell/municipal supply.
In Solapur, water quality swings with borewell vs municipal supply and monsoon turbidity, so the service order matters. A technician typically starts with the basics that can stop production, then moves to filtration stages one by one. If the problem is taste or high TDS, they focus on membrane and carbon stages after confirming flow rate and pressure.
Check water supply and pressure: inlet flow, whether the line is blocked, and whether the RO is struggling due to low pressure.
Inspect pre-filtration: sediment pre-filter condition (clogging), and whether pre-carbon is exhausted.
Verify RO membrane performance: compare inlet vs outlet behaviour, check whether rejection is dropping (often felt as salty/bad taste).
Check storage tank and controls: float/level control, whether the tank is actually filling, and whether shut-off is happening too early.
Look for electrical and plumbing faults: pump operation, SMPS/relay, solenoid valve (SV) function if fitted, and drain line restriction.
Inspect for leakage and sanitation: housing connections, tubing wear, and internal flushing if there is smell or stagnation.
You cannot confirm membrane health without service tools, but you can avoid delays by checking a few safe items. These checks also help WPCI technicians reach the root cause faster when they open the unit.
Check if the inlet tap is fully open and whether other taps in your house have normal water pressure.
Look for visible leakage: under the RO, around filter housings, and near the storage tank connection.
Notice the stage of failure: does the RO start then stop, or does it not start at all?
If you have a TDS meter, test inlet vs outlet (even one reading helps).
If your RO has been unused for days, check if the first few glasses smell odd (stagnation can happen).
Do not run the unit continuously if it is making noise or shows a persistent leak; switch off and call service.
Most RO faults are repairable, but the time depends on what the technician finds. A blocked pre-filter or a faulty float valve can be quick. A membrane replacement or correcting a drain/flow-control issue takes longer because it needs careful flushing and performance checking after parts change. Cost is decided by the exact parts involved (filters vs RO membrane vs pump/electrical), the level of scaling from hard water, and whether multiple stages failed together. If the RO membrane is exhausted, it usually explains the “salty/bad taste + high TDS” pattern, and replacing the membrane often restores performance better than repeated filter changes alone. Water Purifier Care India (WPCI) typically confirms the fault first, then advises whether repair or replacement is the sensible path.
These are typical intervals. Your actual schedule changes with inlet TDS, municipal vs borewell water, and how often you use the RO. In Solapur, frequent turbidity during monsoon can clog sediment stages faster, so symptoms may show earlier than expected.
Stage (what it does) | Typical interval in practice |
|---|---|
Sediment pre-filter (removes sand/rust/turbidity) | Every 3-6 months |
Pre-carbon / carbon filter (improves taste/odour, protects membrane) | Every 6-12 months |
RO membrane (main TDS rejection stage) | Usually 2-3 years, depending on inlet TDS and scaling |
UV lamp (if your model has it) | About 1 year of running time |
UF cartridge (if your model includes UF stage) | Roughly every 6-12 months, based on fouling |
Covered in most services: inspection of pre-filters/carbon stage, checks on membrane performance, flushing, cleaning of relevant flow paths, and correction of basic electrical/plumbing issues.
Covered in many faults: replacing clogged pre-filters and exhausted carbon filters, fixing storage tank filling control (float valve), and verifying pump/solenoid operation where applicable.
Not “covered” by a routine service if the root cause is different: persistent high TDS due to membrane decline will need membrane attention, not only filter changes.
Not “covered” if it is an external supply issue: repeated low inlet pressure from your borewell/overhead tank problem must be fixed at the source for stable RO output.
If there is leakage: the technician will trace the exact joint or housing component; temporary tightening alone is not a real fix if a gasket or tubing is worn.
If your Eureka Forbes RO in Solapur is showing any of the symptoms above, the sensible next step is to stop guessing and arrange a diagnosis visit. Share what you are seeing (slow flow, salty taste, leakage, or no water) and, if possible, your inlet/outlet TDS readings, so WPCI can check the right stage first and restore your RO output faster.
Why Trust Us?
in Solapur — Reliable, Fast & Professional
Technician visits your location for service
Guaranteed service visit in 48 hours for any request
Trained technicians for high quality service and repairs
Only high quality spare parts used for repairs
Watch
FAQ
Find answers to common questions about our services
Eureka Forbes has been selling water purifiers in India for decades, first through door-to-door salespeople and later through shops and online stores. Walk through Solapur's older peths and you will still find Aquaguard UV units bought twenty years ago, sometimes in the same household as a brand-new AquaSure or Aquaguard RO in a son's or daughter's room. All of these are Eureka Forbes products, but they were designed for different water and need different kinds of care.
Older Eureka Forbes purifiers were mostly UV-based. They kill germs effectively but do not change what is dissolved in the water. That made sense when a family drank treated corporation supply every day. Today, with Solapur Municipal Corporation's water from Ujani dam and Hipparga tank arriving only every few days in many wards, a lot of those same homes now top up with borewell or tanker water. Groundwater around Solapur comes from basalt rock and is frequently hard, high in dissolved solids and, according to Central Ground Water Board sampling, often above the safe limit for nitrate.
A UV-only Eureka Forbes unit cannot fix that. When we service an older model, we test your water first. If it is low in TDS, we will keep the UV purifier running well. If it is not, we will say so clearly and explain your options.
Recent Aquaguard and AquaSure RO purifiers add features that earlier generations never had: a Taste Adjuster (MTDS) to control mineral levels, Mineral Guard cartridges, Active Copper on some models, UV in the storage tank, and electronic alerts that announce when a filter is due. Each of these needs its own attention during a service. AquaSure gravity models, on the other hand, depend on a replaceable cartridge and simply stop purifying properly once it is exhausted, so timely replacement is the whole job.
| Unit Type | Common Issue in Solapur | Usual Fix |
|---|---|---|
| Legacy Aquaguard UV | Used on hard borewell water it was never built for | Water test and honest advice on suitability |
| Legacy Aquaguard UV | UV lamp glowing weakly; quartz sleeve coated | Lamp change and sleeve cleaning |
| Aquaguard RO + UV | Slow output from membrane scaling | Descale or replace membrane |
| Aquaguard RO + UV | Alert light stuck after filter change | Correct cartridge and proper reset |
| AquaSure gravity | Water passing but cartridge expired | Timely cartridge replacement |
| AquaSure RO | Pump noisy, tank not filling | Pressure check, pump or valve repair |
Spare parts for some very old Eureka Forbes units are now hard to find, and compatible substitutes vary in quality. If your purifier is more than ten or twelve years old and needs a new board, pump and membrane at once, the repair may not be worth it. On the other hand, a solid RO unit from the last several years often needs only filters and a membrane to work like new. We give you both figures and let you decide.
On corporation supply alone, every six months is a good routine. With borewell or tanker water, every three to four months. Older UV units benefit from a lamp check every year regardless, because the lamp weakens long before it goes dark. Solapur's hot, dry spring is the time to book, before the summer rush.
Bhavani Peth, Mangalwar Peth, Shukrawar Peth, Kasba Peth, Siddheshwar Peth, Navi Peth, Railway Lines, Murarji Peth, Hotgi Road, Jule Solapur, Vijapur Road, Saat Rasta, Kumtha Naka, Akkalkot Road, Gandhi Nagar, Datta Nagar, Majrewadi, Bale, Soregaon and Kegaon.
Water Purifier Care India is an independent multi-brand service provider. We are not Eureka Forbes Ltd and not its authorised service centre. Eureka Forbes, Aquaguard and AquaSure are trademarks of their owner, mentioned here only to describe the products we service. If your purifier is within manufacturer warranty, you may want to contact the company directly.
Call 8506096743 or book online through this page for Eureka Forbes RO service in Solapur.